D P I 610/615 S e r i e s

SETTING THE STANDARD FOR PORTABLE
PRESSURE CALIBRATORS
The technically advanced Druck DPI 610 and DPI 615 portable
calibrators are the culmination of many years of field experience
with the company’s DPI 600 series.
These self-contained, battery powered packages contain a pressure
generator, fine pressure control, device energising (not IS version)
and output measurement capabilities, as well as facilities for 4 to 20
mA loop testing and data storage. The rugged weatherproof design
is styled such that the pressure pump can be operated and test leads
connected without compromising the visibility of the large dual
parameter display. The mA step and ramp outputs and a built-in
continuity tester extend the capabilities to include the commissioning
and maintenance of control loops.
Intrinsically Safe versions are available as complete maintenance
tools and portable calibration standards for pressure instruments and
control loops in hazardous ’Zoned‘ areas. Certified to BASEEFA and
CENELEC standards, the DPI 610IS and DPI 615IS can reduce
response times to breakdowns and emergencies by removing the
need for ’Hot Permits‘ and gas detection equipment. This gives
peace of mind to all those responsible for safety within hazardous
areas.
A highly accurate and easy to use calibrator is only part of the
solution for improving overall data quality and working efficiency. The
DPI 610 and DPI 615, with data storage and RS 232 interface, reduce
calibration times and eliminate data recording errors. The DPI 615
also provides error analysis for field reporting of calibration errors and
pass/fail status. In addition, procedures downloaded from a PC
automatically configure the DPI 615 to pre-defined calibration and
test routines.
Improved performance
The DPI 610/615 series combine practical design with state of the art
performance, summarised as follows:
Accuracy: 0.025% FS for ranges 70mbar to 700mbar
Ranges: 2.5 mbar to 700 bar including gauge,
absolute and differential versions
Integral pneumatic
pressure source: –850 mbar to 20 bar
Integral hydraulic
pressure source: 0 to 400 bar
Measure: Pressure, mA, V, switch state
(open/closed) and ambient temperature
Output: Pressure, mA step, mA ramp, mA value
Energising supplies: 10 and 24 Vdc (not IS version)
Data storage: 10,000 values
Documenting (DPI 615 only): Error analysis with pass/fail status and
graphs. Two way PC communication
for transferring procedures and results.
Remote pressure sensors: Up to 10 digitally characterised sensors
per calibrator.
Simplified operation
Druck’s knowledge of customer needs, combined with innovative
design, results in high performance, multi-functional calibrators which
are simple to use. The key to simple operation is the Task Menu.
Specific operating modes such as P-I, switch test and leak test are
configured at the touch of a button by menu selection.
Featuring highly reliable pneumatic and hydraulic assemblies and
self-test routines, the DPI 610/615 series can be relied upon time
and time again for field calibration in the most extreme conditions.

D P I 610/615 S e r i e s
DRUCK - DPI615PC.pdf
Adobe Acrobat Document 1.2 MB